Had Brivis heating and cooling installed in new house with 2 zone motors fitted. Networker was intially setup to run even when NO zones were selected i found this out after the kids turned it on for hours with no zones selected and froze up evaporator spoke with Brivis and showed me how to setup properly. My question is can the sysytem be set-up to run fan even when compressor switched off like a motor vehicle as currently when comp turns off so does fan and can the delay between the copmp turning off and be reduced as currently if i change zones during running and go past the no zone selection i have to wait 5-6 minutes for the system to come back on.Or is it possible to delete the no zones selected as currently when i push zone button it goes.
Zone1-Zone2-zone1&2 -No zones-then back to start .
Have also measured refridge pipe lengh is right on Brivis max 15 mtrs would the system work any better if topped -up" or should this have been done at the install as i know it wasnt.
Thanks