Heating, Cooling & Insulation
Aug 11, 2021 10:21 am
I'm building a garden studio and have come to order the insulation panels for the floor. I'm going to use PIR panels. These panels come in lengths of 2.4m, The gap between joists I'm going to fit them in is 3m, divided by a noggin midway, so one sheet will leave a gap of 40cm.
My question is, rather than buying a whole sheet for each 1.5m section and losing 1.4m in offcuts, is it OK to join two cut boards together in a single gap?
Thanks in advance for any help.
Sign in or Join to reply to this Topic
PulseReno Concern - Only Nails to connect floor joists to beamReno Concern - Only Nails to connect floor joists to beam
They will probably come back and put joist hangers in later, they need to
lmcavennieSolar hot water system, solar panels and Photo voltaic panelSolar hot water system, solar panels and Photo voltaic panel
Hi Everyone, I am currently in the process of building a home in Alkimos. We will be undertaking our Pre-Start in January and we are completely stuck on what to do with…
CJGEasycraft Panels install & existing Hydronic Heater PanelsEasycraft Panels install & existing Hydronic Heater Panels
Hi, We would like to install half wall easycraft panels, but we have existing hydronic heating panels on some 9f the walls. Hubby is of the opinion the only option is to…
BenmFloor insulation - thermal bridgeFloor insulation - thermal bridge
Hi there, thank you for your reply. I am going to use the method in the reply below. I am just thinking of possibly adding a second layer of board rather than bats to…
iknowitsseriouscost to connect sewrage and power in Brisbane?cost to connect sewrage and power in Brisbane?
I think it's a good idea to find a builder who suits you and ask. That way you're getting the info direct from the builder and they'll be able to work all of that out for you.