Browse Forums Landscape & Garden Design 1 Aug 07, 2017 11:35 am Hello, We have a new build i am looking to start landscaping from scratch. I have planned out where i want everything to be on sketchup including creating layers for where i would ideally want mains fed garden led lighting and irrigation lines/solenoids. i am now looking for advice in regard to running the cabling for low voltage wiring, solenoid switching wires and irrigation pipes, specifically at this early stage determining what piping i need to run to house the electrical cable, whether i can put switching wire and light cabling in the same pipe, how deep below the surface it needs to be and whether my irrigation piping and electrical piping can go in the same trench. cheers Hi all I am looking to run a water line under my concrete footpath which is directly next to my home, was seeing if this is possible without cutting the entire section… 0 20179 Hi Brainstrust, I had a go at creating my own irrigation plan, keen to get some feedback. It will be run from one 750-800W pump, off 2* 5000L rain tanks. Each zone… 0 22757 1. Roof cleaning and paint - which colour do you recommend? I often see black/ dark grey in use these days but I would prefer… 0 8324 |