Browse Forums Landscape & Garden Design 1 Jul 26, 2012 5:24 pm Hi everyone, I've been busy for a while and I'm looking at setting up a small garden shed at the back of my block of land. I have looked at this one: http://www.cheapsheds.com.au/product/12 ... er-g66-cb/ in the smooth cream colour. They have a flooring frame with it that I would use and just buy ply wood locally and have a nice ply wood floor for it. The area I am looking at is sloping down so, I’d have to use brick on concrete support at the back to level it out. So, what do you think guys? I have another 2 weeks or so before I get this, so any ideas or suggestions are greatly appreciated. Re: Garden Shed 3Jul 31, 2012 4:38 pm Hey AdamBorzy2012 , If it makes any difference I was looking at buying through these guys.. by far the cheapest I have seen and pretty good rates. Unfortunately I don't know much about the situation of yours as mine will be on a flat slab. Re: Garden Shed 4Aug 01, 2012 12:52 am Victoria_g06 Hey AdamBorzy2012 , If it makes any difference I was looking at buying through these guys.. by far the cheapest I have seen and pretty good rates. Unfortunately I don't know much about the situation of yours as mine will be on a flat slab. That's great at least you don't need to put a foundation and level out the floor in case you buy the shed. I’m also considering re-grading the soil to flatten it out, another cheaper solution I guess. I’m not a compulsive buyer myself, did some research and all, found out that they really have the cheapest shed available. I reckon at a very reasonable rate; other sheds are just way too costly for my pocket. I’m pretty sure it will make a big difference. Why would they even care to say to give a warranty of 20 years if ain’t Australian made? You know what that means, anything manufactured 'here' are of high quality and made to lasts. Is it possible to render an old corrugated iron shed.I have heard that it can be done if it is covered with chicken wire first.Not sure of the ratio of the render mix and… 0 4907 Thanks. Yeh ideally that would have been good, but have progressed too far now. Hoping some well placed internal walls fixed up into the battens will provide some… 2 5421 Hi, I am sheeting the inside of a 5.7 x 8m shed with gyprock. Unfortunately the shed wasn't designed for internal cladding but I have been framing it up as strongly as… 0 3428 |