Dec 28, 2019 10:55 pm
I've just finished demolishining a deck that was a suspended slab design. My issue is that the concrete slab extends into the house under 3 doorways.
I have removed as much concrete as I can with the jackhammer but need a nice flat surface to attach a waling plate to for the new build.
What's the best way to grind the remaining concrete down? Lots of info out there for grinding concrete but not so much for my application.
Was thinking about trying a cup wheel on the 5" grinder but I'm starting with a pretty rough surface (off the jackhammer) I've never used one personally and not sure if it would be up to the task.
Thanks for taking the time to read this,
Re: Grinding concrete flush with brick wall3
Jan 29, 2020 2:00 pm
How is this going? Have you done the job yet? If it was my place I would just keep using the Jack hammer on the concrete until it was flush.
Yeah, sorry about the late reply.
I purchased a segmented diamond cut off wheel for my 5" grinder and made a series of vertical cuts about 10mm apart, then chipped them away with a hammer.
Will probably get some epoxy filler to repair the areas of concrete that have broken away/level the surface in preparation for a deck ledger board to be installed.
Sign in or Join to reply to this Topic
John0322Concrete sleeper retaining wall design flushed to brick wallConcrete sleeper retaining wall design flushed to brick wall
Thanks for you reply. I have stormwater lines on my property. The wall we are building will be at the fenceline boundary. The ag lines will run on the neighbour (higher…
cs212Small gap between brick post and wall.Small gap between brick post and wall.
Hi, After amending our house layout.. we’ve totally overlooked that one of the front brick piers will leave 13cm gap between the post and the exterior wall of the front…
alexp79Sisalation Paper on boundary brick wallSisalation Paper on boundary brick wall
In reverse brick veneer construction, you would need reflective but vapor permeable barrier from the outside side of your timber frame, but also optionally can add a layer…
arcadeltindoor exposed brick wall sealerindoor exposed brick wall sealer
Fair enough. Must be something about the way bricks are made, as our recycled brick wall doesn’t drop dust at all, unless you rub it with something abrasive.
building-expertRaising height of brick wall using existing footingsRaising height of brick wall using existing footings
In Victoria retaining walls up to 1M high are exempted from building permit under schedule 8 of the Building Regulations