Browse Forums DIY, Home Maintenance & Repair 1 May 01, 2013 8:07 am G'day guys. Need a little help with sanding and finishing our cypress floor boards that have turned into a burnt orange colour (same old story) I'm looking for any advise on this product (see attached pdf) in regards to what finishing sand grit would be required before applying this Liming white finish; and is 'very fine' sanding between coats required (due water-base)? and would a sealer/primer be required for this?. Has any one had any experiences with this product? if so, good or bad. Any advise would be greatly appreciated. Cant seem to attach pdf. not sure why. will try to upload asap 4 14468 Building Standards; Getting It Right! But they didn't even leave it at one level it goes up and down along the whole front of the house 4 10949 Broker here - legislation says that every true broker must put the clients best interests before theirs so in theory they must offer you the best options for you on their… 2 46019 |