Have never worked on gutters before so need advice please.
I have to replace about 18 metres but luckily dont need to disturb corners, so it's all straight line.
Stratco advised cutting a piece off with an angle grinder so they can match the profile.
Do I just push back the roof tiles and unclip from the front then the back and remove?
When fitting the new gutter is it just a reverse of that in clipping the back then the front?
When I join 2 pieces do you just slide one end into the other and how does it fit if the profile is identical, and how much of an overlap do you recommend?
Someone said to put sealer on the join and to blind rivet the front top, is that recommended?