Browse Forums DIY, Home Maintenance & Repair 1 Apr 20, 2024 10:51 pm Hi everyone Question about Brevis gas heating undergound - was recently installed by previous owners (<1 year old) but live in a relatively large house - 4 bdr - and only 1 room and the toilet heat up well - all other areas lounge and other 3 bdrs dont heat up. Overall there are about 8 ducts around the house- 2 get good warm air flow the others are very mininmum (but there is some flow only). Just wondering what are people's thoughts - i cant see any obvious leak (shone a light at night through the ducts) a fiber light i pushed through the tunnel -I was planning to consider this option: The house is arrange in two large areas- so going under the house and closing the whole duct to the 2nd half of the house physically- so the heating is only to the lounge and 1 bedroom and toilet 1. Just wondering how I would be able to physically close off the area by going under the floor- do i just cut the duct at the area and just place a piece of plywood over and seal it - maybe use some foam as well as per https://ecomasterstore.com.au/products/duct-sealing-kit 2. Was thinking of this method- https://www.youtube.com/watch?v=aCCWAmESK4w 3.My research shows it can cause pressure effects and affect the mechanics- but really the duct heating is quite bad so i'm happy to take the risk Thanks! DIY, Home Maintenance & Repair Hi, recently a replacement rangehood was installed at my home and the installer cut holes through the double brick wall for the duct but left quite some damage to the… 0 7547 Make sure that the weep holes are clear and free to drain which should be on the underside of the sill, provided that the window is the right way up, 5 9864 DIY, Home Maintenance & Repair It looks like they have used rigid sealant in the gap. You are supposed to use flexible sealants in filling this gap to allow for expansion and contraction movement… 1 14609 |