Browse Forums DIY, Home Maintenance & Repair 1 Dec 26, 2023 10:05 pm I have just ripped out built in corner furnishings fitted 2004 at build. This ground floor entry has this short length of wall built into a block length retaining wall, property is on a slope so neighbours garden starts half way up the wall. During heavy rains there is seepage onto the tiles and in the past two years of ownership the plasterboard and paint have perished. Clearly last owner painted over some major issues. I need advice on how to approach the problem now. I am hoping there are treatments I can apply to the bricks to make them fully waterproof. Also any suggestions around home insurance ? Isn’t this a structural claim ? Can’t believe a builder was allowed to do this in QLD. Re: ‘Basement’ waterproofing bare bricks 3Dec 27, 2023 5:30 am to do it properly you need to dig out the garden and waterproof the outside of the wall. There are some products you can put on the face of the bricks but the water is still in the porous block wall and will cause damp issues where it can escape. You could be looking at anywhere between $400,000 to $800,000 depending on so many variables including: 1. Site conditions - what material is being excavated 2.… 1 12213 Just got response from council. Pouring concrete into subfloor does not require any building permit. 4 11308 |