Aug 13, 2019 10:11 am
I have a wooden table that is situated on a covered deck. It does get some sun during the day, but not excessive and if it rains really hard with lots of wind it gets a bit wet. Again not excessive.
I plan to strip back what is remaining of the current coating, sand and then top coat it again in a suitable clear product.
So, my question to all you learned and experienced people is what is the best product to use for the new finish? Bearing in mind that:
1) it has to stand up to the use of being used as a table top, i.e. plates scraping over it, warm dishes (not hot) being placed on it etc.
2) It will be exposed to some sun
3) it will be exposed to some rain
I am not particular about if it should be oil based or water based and also not particular about which manufacturer.
Thanks in advance,
Sign in or Join to reply to this Topic
alexp79Do you know the aluminum furniture that looks like wooden?Do you know the aluminum furniture that looks like wooden?
Eco BuilderWooden boards screwing standardsWooden boards screwing standards
The information the landscaper has given you is incorrect. Australian Standards stipulate 2 screws per board/joist Ideally you should be staggering the fixings as well -…
TtrhHow to install a wall plate with a wooden stud in the middleHow to install a wall plate with a wooden stud in the middle
Hi guys I’ve tried to install an electrical wall plate by cutting through plasterboard with a c clip although there is a stud in the middle and can’t get the wall…