Browse Forums Outdoor Living 1 Sep 28, 2014 8:16 pm I have to install a tank after the meter with a pressure pump to service the new dwelling (see image) https://www.facebook.com/Vegnoutfarm/ph ... =1&theater I am going to dig the tank into the ground to get maximum flow into it but have a question. It is a top fill type poly tank I need but all the ones I see for sale dont seem to have a top female thread for inflow? Also they dont have a valve system set up to cut the flow when it reaches the top. My specific question is: Do I have to then plumb the meter side into the very top of the tank through one of the lids? Also, do i have to setup a custom float system? Are there not tanks that already have the threaded inlet at the top and accessory float systems that fit straight onto the tanks they come with? That was always going to be a challenge and a test of patience. Full marks to your mate. Did you discuss the wet area near the trampoline? 16 18270 If you can calculate the reasonable charged head from let's say 100mm below the gutter to the top of where the vertical riser's horizontal discharge pipe will be, that… 11 17971 Grate, thank you! RexChan if thats the reason i could sleep well without thinking about additional cost. But 1st i'll need to read about NRV cleaning/replaing stuff. I… 7 31921 |