Hi
My diamond gloss white valencia benchtops have been installed.
The join on the right hand side looks pretty good however the join on the left hand side starts to open up as it comes towards the wall. I expect the left hand join to look like the right hand join.
Would you accept this or should I push for this part of the middle benchtop piece (which has the sink cutout) to be replaced? I am concerned about the potential for future swelling with water seeping through as it is near the sink. The substrate is 40mm particleboard - not sure if it is HMR.
Is there anything that can be applied to disguise it? We are close to handover and with Christmas round the corner this will cause delays.
thanks yee all !!
left hand join pic 1
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
left hand join pic 2
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
right hand join
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅