Browse Forums Kitchen Corner Re: Advice needed re kitchen renovation 4May 07, 2012 6:46 pm Cutting Edge Kitchens and Cabinet Making http://cuttingedgekitchens.net.au http://www.facebook.com/pages/Cutting-Edge-Kitchens/290484196676 Mobile : 0419 430 575 PH: 9452 4772 Fax :9452 4772 cuttingedgekitchens@outlook.com Re: Advice needed re kitchen renovation 7May 08, 2012 7:12 am Cutting Edge Kitchens and Cabinet Making http://cuttingedgekitchens.net.au http://www.facebook.com/pages/Cutting-Edge-Kitchens/290484196676 Mobile : 0419 430 575 PH: 9452 4772 Fax :9452 4772 cuttingedgekitchens@outlook.com Re: Advice needed re kitchen renovation 8May 08, 2012 4:08 pm Hi there, We currently have in our place (soon to be smooshed) full gloss white poly cupboard doors with the u-shaped handle-less top (not shark edge). We find it great, we've had a few chips over the years but it's been from banging a pot right on the edge/corners, no chips/damage at all on the 'front' of the doors. It's a breeze to clean, and looks stunning. Benchtop we've gone with Caesarstone Nougat. And as Dreamer said before we also have 3 drawers under the bench in most places we could, 2 larger ones down the bottom and a cutlery type depth on top. For the kickback we currently have full gloss white poly also, however I'm debating whether we do this again in our new place we're planning. EDIT: I accidentally words Assuming the structure of your cabinetry is good then I would DIY everything as follows: - replace your counter tops entirely, - replace all drawer runners with soft close… 1 4776 I recently went through a similar renovation and move scenario when updating our family home. We also swapped some rooms around and tackled a major… 2 9755 Hi All, I engaged a tradie to install concrete retaining wall 600-800mm high over 32 meters in Victoria. Sleepers are 200*75*2000 mm installed over 17 steel posts. I… 0 6888 |