Browse Forums Kitchen Corner Re: How do you change the washer in a mixer tap? 4Oct 07, 2012 1:33 pm If it's a "Flick-mixer" style (not necessarily that brand) you'll actually find they are sealed "cartridges". Pull the tap apart as "tengals" said (normally a pin to remove either the top or trim "jewel") to access an Allan Key grub-screw. Loosen or remove screw, remove top, lift out cartridge. There's only two or three different types, I saw them at Bunnings the other day for, umm....it was around $25, give or take a dollar or two. Reassemble. P_D (Did you read tengals tip about shutting the mains off first !!! ) . Block settled 07 June 2011 Our little piece of the Interwebs on HomeOne....... viewtopic.php?f=31&t=48577&start=0 that will depend on the kitchen bench depth. you'll have to specify it so it allows for both the tap and the sink 1 7396 7 5142 Brass or 2) Stainless steel made - which Kitchen tap is good for drinking.Brass kitchen taps in Australia contain lead… 0 6738 |