Browse Forums Kitchen Corner 1 Oct 09, 2009 8:41 am Hi all, We are in the finishing stages of our Kitchen/Living/Laundry/Lounge room renovation. Look process, and very annoying to be without a kitchen for 6 weeks. BBQing is great, but not in the cold and wet! Anywho, installed the sink the other day and found that the Stone has been incorrectly cut. The sink only just covers the hole (maybe 3-4mm around the edge) and I'm really not happy with it. When the front is in position, the back edge of the sink falls into the hole.... Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ By bassjunkypete, shot with iPhone 3G at 2009-10-08 Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ By bassjunkypete, shot with iPhone 3G at 2009-10-08 What are your thoughts? Anyone ever had this before? Thanks in advance. Cheers Pete Re: Ceaser Stone, big problem.... 2Oct 09, 2009 9:03 am If it were me I would be requesting....no, demanding a new piece be cut, it was their responsibility to have the correct measurements of the cutout for the sink, so it's their responsibility to fix it. Re: Ceaser Stone, big problem.... 3Oct 09, 2009 2:09 pm So far they are coming out tomorrow to add a section where they have made the mistake. It should be ok, it won't be seen as the sink will cover the repair. Not ideal of course, but a lot better than a team of guys with sledghammers and picks and chisels removing the whole kitchen :S Cheers Pete Dear Members I have to decide the Facade column size. My custom builder standard is 350mm with rendering, but i asked for 470mm plus stone or tiles and yet to get… 0 7497 Hi, planning on using the attached stone pieces in my bathroom. I want to remove stains and gloss seal. Can I get some advice on best way to remove stains and best… 0 6709 |