Browse Forums Kitchen Corner 1 Oct 23, 2008 8:59 am my builder uses poltex vacuum sealed doors (limited colours) so going with classic white I don't know much about these they do come in lots of profiles can any tell me whats a good profile
I am looking for that modern look of white with ice snow tops it has Island bench 2.6m long with undermount sink the slash is oppsite and is only 2m long any colour ideas "please" floor light redish timber and handles 3 sets of drawers under cooktop area is long in or out the bulder only had ones about 15cm in a square set all others were curved also polished look or brushed look Re: handles and profiles and slashbacks 2Oct 25, 2008 8:41 am what do you want the splashback made of? glass, tiles, stainless steel?
with the handles I would get brushed stainless. If vacuum sealed doors is the same as vinyl wrapped then it is good cause you dont get edges peeling off and they look great. White is good too, with the white benchtop very modern but will always look good. here are some white kitchens.... a glass splashback painted white is good and is very easy to clean (no grout). handles: i think you meant that you have wide draws under the cooktop i would try to have the same sort of handle throughout the kitchen (just in different sizes) you can get really long stainless handles like the ones in the photo's, lincoln sentry is a good place for handles. Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Maleena Hardy Curiouser & Curiouser Vintage-Handmade-Interior & Colour Consultancy http://www.curiouserandcuriouser.com.au 3 3965 I recently went through a similar renovation and move scenario when updating our family home. We also swapped some rooms around and tackled a major… 2 9871 OK it's been a little while! I've been busy getting time where I can to work on this. I started by grading a pad (borrowing a… 26 19966 |