Browse Forums Finishing Touch 1 Aug 08, 2015 4:55 pm Been trying to find a product to use on a mass quanity scale, abit like a "Canny" project I saw in Melbourne. Can anyone advise of a cost effective solution to achieve this look? Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Hi, Currently building, we are on a sloping block so we have from floor level to the roof in axon cladding. Below floor level to the ground I want to put brick facings /… 0 4723 The spacing of the studs looks pretty large especially for a load bearing wall. 3 11389 Re my second point – yes exactly. And often it may take additional time if the manufacturer recommends no more than X meters… 3 5910 |