Browse Forums General Discussion 1 Sep 22, 2018 12:56 pm hi All ...had my Slab Pour last week - few pipes protruding outside of the slab on both the sides and SS says no issues within tolerance i dont have an inspection arranged on it frame ? any comment will be helpful..tia Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Re: Slab Issues 3Sep 23, 2018 8:24 pm Without reviewing drawings I cannot be sure however it looks like the pipe on the edge is supposed to be sewer vent. It will most likely be terminated at slab level with a reducer, allowing 50mm vent pipe to pass through your frame. Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Slab Issues 4Sep 24, 2018 4:46 pm building-expert Without reviewing drawings I cannot be sure however it looks like the pipe on the edge is supposed to be sewer vent. It will most likely be terminated at slab level with a reducer, allowing 50mm vent pipe to pass through your frame. thx . its on both sides of the slab so was worried . is it something to worry abt 12 5320 I am looking at building a house. Has anyone used Construkt Homes (based in Adelaide)? Does anyone have experience with this builder? 0 6450 Industry type domestic contracts are prepared by industry bodies for the benefit of the builders. This means that if you are the owner watch out. One of the points is… 0 3226 |