Browse Forums General Discussion 1 Aug 29, 2016 8:39 pm After some advice regarding power points. I have a wall that was uneven so I have attached some cement sheet to rectify the problem before tiling over it. Now the power points are set too far back in the wall and I want to bring them forward so they will sit on top of the tiles I will lay. Is there a proper method for doing this or do i just unscrew the plastic and pack it with cement sheet until it's out to the desired distance? Thanks! Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Hello everyone, I have a question regarding moving a chandelier after it has been mounted. The chandelier in question is quite large, measuring 4 meters… 0 72331 Looking to tile the facade pillars rather than rendering. Builder is quoting 2500$ laying cost for upto 10msq. The 2 pillars come to be 16msq. So laying costs are 5000$… 0 7524 Hi, I'm clearing the tiles from our horrid 50 year old bathroom and preparing to lay new ones. Bugger of a job getting the old… 0 8084 |