Browse Forums General Discussion 1 Oct 02, 2015 10:38 am I have salvaged some thin sheet metal that I want to use for a hobby project. I was wondering if anyone knew of an easy way of flattening it out (it has some bends in it)? I have tried hammering it but have found that this is hard to do in a way that flattens it properly. Fine with me... just let 'em step in with some affordable (but good) gear... 12 5479 4 14257 Unless there is something in special conditions the builder does not have to give you timeline. If your demolition contractor has not removed Asbestos and it was found… 12 28775 |