Browse Forums General Discussion Re: Insulating a shed roof with polystyrene 2May 24, 2015 2:31 pm Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Insulating a shed roof with polystyrene 4May 26, 2015 6:20 am Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Insulating a shed roof with polystyrene 6May 26, 2015 10:21 am Foremost Building Expert in Australia,assisting with building problems/disputes, building stage inspections,pre-contract review advice for peace of mind 200 blogs http://www.buildingexpert.net.au/blog Re: Insulating a shed roof with polystyrene 13Jul 22, 2015 10:27 am robbie_p I think ill go with Foilboard (25-30mm), as mentioned above, with a 10-20mm gap would be a good idea.. i think Foilboard works out cheaper than polystyrene (which i didnt know) I think you will find foilboard is polystyrene inner with a foil face. Is it possible to render an old corrugated iron shed.I have heard that it can be done if it is covered with chicken wire first.Not sure of the ratio of the render mix and… 0 4898 Thanks. Yeh ideally that would have been good, but have progressed too far now. Hoping some well placed internal walls fixed up into the battens will provide some… 2 5416 Hi, I am sheeting the inside of a 5.7 x 8m shed with gyprock. Unfortunately the shed wasn't designed for internal cladding but I have been framing it up as strongly as… 0 3427 |