Browse Forums General Discussion 1 Feb 20, 2015 1:06 pm Hi All, I have colorbond steel post and rail fence at the bottom of my property. I need to get access to that park of the property, so I’m looking at getting a double gate (about 2 metres) installed, which is going to costs about $1200 (seems quite expensive?), OR simply removing a section of sheets and rail (top and bottom) when needed. Access is only going to be needed very occasionally, but if its fairly quick and easy removing panels and the rails (top and bottom) I wont bother getting a gate installed. Is it fairly quick and easy to do? If not, I might just get the gate installed. Cheers, Robbie Re: Steel post and rail fence - need to get access 2Feb 20, 2015 1:12 pm It normally takes me about 10mins to take a panel out, or replace it. The Harder You Try - the Luckier You Get ! Web site http://www.anewhouse.com.au Informative, Amusing, and Opinionated Blog - Over 600 posts on all aspects of building a new house. Re: Steel post and rail fence - need to get access 4Feb 20, 2015 1:46 pm taking out the top rail and panel takes us about the 10 mins also Hi I am wanting some opinions about the build of a steel shed I am going to get one about 4.5 x 2.5 m steel shed and the height will be about 2.3-2.4m high The one I am… 0 10546 That just protects from further rust, l want first to apply a rust converter or rust killer to kill the rust thats there, whats the best one for galvanized steel 2 1497 Electrical just got back to me and said the most they can provide is a single power point on the Bedroom 1 side of that wall. After handover, your towel rail installer… 2 1057 |