Browse Forums General Discussion 1 Jan 21, 2013 1:07 pm I have a side fence that I would like to convert to an outward swinging gate and wondered if there would be any issue in doing this? I would have to put I a new post and ensure it is hung correctly (also thought about putting a small jockey wheel on the gate to assist with weight. The fence panel is 175cm in length. Has anyone done anything like this themselves, or am I better off getting someone to make a custom gate and fitting? Trying to keep the $$ down hence the conversion idea. (see pic here: Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ ) Re: Turning side fence into gate 2Jan 27, 2013 9:31 am Yes - I have to have a gate - but not CB. Thinking wrought iron but large enough to get a bob cat through. Hi, Building a new place and I have limited space from garage to fence. 3130mm width, then opens up over 5000mm once I pass tmy garage. I need a fence that goes from… 0 3976 DIY, Home Maintenance & Repair I mean, I install them/sell them for a living so I haven't done DIY, unless you count the first one I installed lol. (electrician by trade). Usually a 6-8 hour job for… 3 42326 Hey everyone Not for me or anyone I know, just generally interested. For a single allotment house, are you allowed to take the fence on both sides of your house and… 0 21584 |