Browse Forums General Discussion 1 Jun 14, 2009 8:07 pm I need to cut some flormesh, it's expanded metal. The cuts are 5mm thick and 14mm long. There will be about 400 cuts. I'm looking at hiring a 240v circular cold cut saw. Is this the best way to go? Is there anything to watch out for using this type of saw? Re: Cutting expanded metal 2Jun 24, 2009 2:14 am Use Smith & Arrow. It's great, so i recommend you use it. (http://stores.shop.ebay.com.au/smith-an ... QQ_armrsZ1) If you don;t believe me then you can read all the positive feedback from all the 6000 sales. You are fine. The concrete is never going to explode. Worse case scenario is that it develops a crack from different rates of expansion but hopefully it's got some… 5 4509 Fine with me... just let 'em step in with some affordable (but good) gear... 12 4275 |