Hi All
I have a box of quality drill bits that seem to be new but their engraved sizes covered by rust ,,,,I tried to sand them to see their sizes but still I am finding difficulty
What would be the correct way to determine the drill bit sizes?( i.e. Measure tip of a bit or flute of a bit or shank of a bit )?
Attached photos showing 4 new Sutton SDS plus for masonry (4mm, 6mm, 11mm, 16mm) not been used and still have their tags showing sizes
SDS bits their tips are wider than the flute unlike other types
I tried to do a test by using 3 different types of drill gauges but I can't fit the drill bit size 4mm into the hole 4mm and same issues with other sizes 6mm, 11mm, 16mm
Thx Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅
WatchingStarredHistory
MembersPros
Browse Forums General Discussion put the 2 draw set directly under the cooktop and the 3 draw set either side for balance 1 11422  Hi the designer has said that cantilever is 4.18m long and 7m wide is that normal size? we had to increase upstairs bedroom by 200mm and i know nothing about this beam… 0 7239 |
