Hi,
Currently building, we are on a sloping block so we have from floor level to the roof in axon cladding. Below floor level to the ground I want to put brick facings / tiles (bricks sliced thin) on cement sheet. I have found a good brick product that will suit. We don't have footings to do real bricks so thought this was a good alternative. Have seen it done before and looks good.
The builder is worried that where the sheet and bricks meet the ground they will get wet and over time the adhesive will deteriorate and the bricks will fall off or just generally become in poor condition.
Looking for anyone's experience or thoughts and advice on trying to get this done or if I should look at a different cladding alternative.
Cheers
WatchingStarredHistory
MembersPros
Browse Forums General Discussion DIY, Home Maintenance & Repair All my inside walls are Fibre Cement & House has Steel frames... Tricky when one wants to hang pictures or do Wainscoating Paneling up the hallway. Those little nail… 0 9432 Thanks for that. I think the mortar has been sitting on these surfaces for approx a year. We’re at handover & they tried to get it off the rubber but have damaged it… 3 6647 DIY, Home Maintenance & Repair I do it all the time - units, mm/m, kpa/mpa etc and I still get on google and check it - it's easy to be out by a factor of 10, 100 etc 5 7291 |
