Browse Forums General Discussion 1 Sep 12, 2021 5:45 pm I'm looking at installing anticon 60 insulation in the walls of a shed that I'll be building on the next few weeks. Main reason is it won't require internal cladding and is relatively inexpensive. The shed has steel z purlins and will be clad with monoclad tin. Can anyone tell me what the compressed thickness is of anticon 60? I'm thinking the 16mm wall screws provided will be too short... any tips from people who might have attempted this are welcome! Is it possible to render an old corrugated iron shed.I have heard that it can be done if it is covered with chicken wire first.Not sure of the ratio of the render mix and… 0 4897 Thanks. Yeh ideally that would have been good, but have progressed too far now. Hoping some well placed internal walls fixed up into the battens will provide some… 2 5412 Hi, I am sheeting the inside of a 5.7 x 8m shed with gyprock. Unfortunately the shed wasn't designed for internal cladding but I have been framing it up as strongly as… 0 3426 |