Browse Forums General Discussion Re: wainscoting wall panel boards 17Jun 10, 2021 6:42 pm Stewie D You don't need a laser level but a straight edge a couple of metres long to see where high points on your brickwork would be handy. Pack them out and/or plane the battens to suit. Studs are usually 450 -600mm so I'd err on the side of caution and make them 450mm but that also depends on how thick your mdf is as well. Stewie Stewie, just wanted to check should I lay my battens at 450mm space horizontally or vertically? 4 4220 I'm about to put down some Merbau. Is it necessary to oil underneath the boards before laying? 0 760 Thank you again Simeon.. I will call my certifier for that. Have a good day 4 1328 |