?
ROOF FLASHING
Page 1 of 1
Can someone advise if my roof flashing is ok ? do they look compliant ? We didn't elect to use zincalume . shouldn't this be colour bond as colour bond was used everywhere else . It looks like a bad patch work . There is silicon between the zincalume and brick. Is this the proper way of doing it ? Thanks so much !
?
?
Yes it should have been colorbond and no its not compliant. Pressure flashing must be fixed to wall not exceeding 100 mm centres.
Workmanship is sub standard and non matching flashing widths are not acceptable.
Workmanship is sub standard and non matching flashing widths are not acceptable.
I know this post is from a while ago, but the VBA has some good guidance on this.
https://www.vba.vic.gov.au/__data/asset ... 5-Roof.pdf
https://www.vba.vic.gov.au/__data/asset ... 5-Roof.pdf
Related
7/05/2024
7
Coming back to this.... When installing a pressure flashing, what fixings would you use (please give a link) ? Above Pedro said nylon anchors. Anyone have a preferred…
4/10/2023
2
AFAIK, flashing is a minimum standard. Out of curiosity is your window glass stamped with AS requirements in any of the corners of each pane? Im almost certan if theyre…
31/01/2024
1
Building Standards; Getting It Right!
There doesn't look to be any rebate in the slab to prevent water from scooting under the window. AS4654 is the Australian standard to look at/refer to. They have…