Hi. Newby here. I need some advise on a shed I'm going to build. Its a 4800 x 2800 x 2500ish flat roof ( slight fall ).
Firstly I'm after some advise on timber sizes for the stud walls? its going down on a slab. What size studding? I was going for 90 x 35? Also do I bolt the bottom plate straight onto the slab or use a moisture resistant timber first or wrap some waterproofing around it? 2 x top plates? What size centres for the studding? Thanks in advance. DCM.
Shed build
Page 1 of 1
Related
15/06/2023
2
Thanks. Yeh ideally that would have been good, but have progressed too far now. Hoping some well placed internal walls fixed up into the battens will provide some…
14/06/2023
0
Hi, I am sheeting the inside of a 5.7 x 8m shed with gyprock. Unfortunately the shed wasn't designed for internal cladding but I have been framing it up as strongly as…
12/07/2023
1
DIY, Home Maintenance & Repair
I'm in WA and our sandy soils make drainage a bit easier but this is what I'd be doing. Dig down to your footings and let the wall dry out. Clean it all well by brushing…