Browse Forums Building A New House 1 Dec 15, 2023 7:46 pm This plate is part of garage door frame , there is one on each side Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ After the brickies did their job, one of the plates completely sits on the Pillar, while the other one is not completely sitting, and has like 5mm of gap, The screws that you see in the above picture are completely submerged inside the pillar though The question is, will this small gap between the plate and pillar have an impact on the structural integrity? Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Looking to tile the facade pillars rather than rendering. Builder is quoting 2500$ laying cost for upto 10msq. The 2 pillars come to be 16msq. So laying costs are 5000$… 0 8585 get them to replace the chipped tiles. It will stick out like a sore thumb overwise. Also tiler will be siliconing the miters rather than grouting. Grouted miters crack… 1 4242 Hi, have purchased a house with 2 single garage doors. The Centre pillar one side sits proud to the other. Can I change 2 doors into one. Please see picture. 0 7378 |