Browse Forums Building A New House Re: JG King modified Heywood - Contract signed! 343Jan 25, 2017 7:30 am Our Build Thread - JG king Memphis Re: JG King modified Heywood - Contract signed! 351Feb 06, 2017 10:49 am Our Build Thread - JG king Memphis Re: JG King modified Heywood - Contract signed! 353Feb 06, 2017 10:57 am Our Build Thread - JG king Memphis Re: JG King modified Heywood - Contract signed! 356Feb 06, 2017 1:45 pm Great news bank! I have everything crossed for approval asap fir you Re: JG King modified Heywood - Contract signed! 358Feb 06, 2017 6:42 pm Yippe that's great news now hope approval gpes through quickly there. Our Build Thread - JG king Memphis Re: JG King modified Heywood - Contract signed! 359Feb 07, 2017 12:11 pm Council has let us know that the letters for our neighbours comments have gone out today! Yay! So glad it didn't take him weeks to look at it again. I found it very amusing that our admin bolded the bit of her email where she asked him to do it quickly . The neighbours have until the 21st to respond, fingers crossed they send it back sooner. Now the council guy has asked for our developer approved plans to be sent through , which of course we don't have because they were only resubmitted yesterday. We have emailed our contact at the developer to see if he has any influence to get it done quicker than the 2 weeks we are expecting. The drawings also went straight from drafting to engineering yesterday. This time they have added the sewer pipe that is in our easement (presumably because we are closer now) however when we checked them last night we realised that they used the size and position of the pipe that is in our rear neighbours easement, not ours. Ours is a smaller pipe almost 3m down, theirs is only 1.35m down, so bit of a difference. Easy enough mistake to make but I'm sure the drafty will be kicking himself. Hopefully won't be an issue because it was correct on the first lot of engineering drawings but we have alerted them just in case. Some dimensions in the kitchen also jumped off again, must be a glitch in the matrix, i think this is the third time we've had trouble in the same spot . We are hoping to be all done and have the building permit by the end of the month and the builder has confirmed that this is what they are aiming for as well I would never build with Fowler homes. I built with them in 2021 and till date maintenance issues are pending. All their existing trades and businesses don't work with… 14 108489 1 9898 Hmmm, I have checked your past posts and it seems that you are in NSW, not WA as I had thought. It pays to show your State in your avatar. Retaining wall regulations… 5 8156 |