Browse Forums General Discussion 1 Sep 30, 2023 9:18 pm Hi all, Not sure if this is a good place for this question but I guess we'll find out! I'm a novice, building a modular room inside my garage/shed and need to create temporary bracing to ensure the walls stay up during the build. For reference, the walls are a high density straw panel, install using galvanised steel channels. Does anyone have any tips for a non-destructive way of bracing the walls (see photos) while continuing to build? Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Like ⋅ Add a comment ⋅ Pin to Ideaboard ⋅ Any suggestions would be greatly appreciated! Hi JW I just read your post and I find this situation quite strange. When we build, we get a temp pole for construction which becomes the permanent pole for one of the… 1 4009 Thank you again Simeon.. I will call my certifier for that. Have a good day 4 6047 Hi All, I engaged a tradie to install concrete retaining wall 600-800mm high over 32 meters in Victoria. Sleepers are 200*75*2000 mm installed over 17 steel posts. I… 0 7239 |